--- NxtPhase ---

Parameters

 Config:

   Mono

      basic mono phaser
      - Left & Right channels are summed
      - output feeds a single phaser chain

   Mono to Stereo

      mono in / "stereo" out
      - Left & Right channels are summed
      - phaser signal phase is inverted in one side of the output
      - creates the illusion of a stereo image

   2 Channel Single phase LFO

      2 mono channels - one for Left & one for Right
      - Left & Right share common in-phase LFO

   2 Channel Dual Phase LFO

      2 mono channels - one for Left & one for Right
      - Left & Right *LFOs* are 180 degrees out of phase

 LFO Range  :  Low | Nom
 LFO Speed  :

   0.1 Hz to 10 Hz (nom range)
   0.01 Hz to 1 Hz (low range)
   (each range covers 2 decades)

 LFO Low Freq Limit 
 LFO High Freq Limit

   sets the (nominal) shift frequency range
   Indirectly controls the depth level of the LFO
   Both controls have exactly the same range of values
   - Low Limit value must be strictly "below" the High Limit value 

 Phaser Stages :  4 | 6 | 8 | 10 | 12 | 14 | 16 | 18 | 20

   sets the number of Stages from 4 to 20 (even numbers only)
   - each pair of stages produce a 180 degree phase shift
   - each 180 degree phase shift produces one notch

 Feedback  

   sets the intensity of the peaks
   Care must be taken with this control
   - at the max it can (nearly) self oscillate

 Mix  - Mostly Dry (full CCW) to Mostly Wet (full CW)

   controls the wet/dry mix 
   - note that full Wet or full Dry produces no phase effects so ...
   - the mix range has been slightly restricted 

 Polarity  :  in | out

   sets the polarity of the Wet (phased) signal in the output mixer

 Out Level : -8 to +16 dB
   
   Used to adjust the overall output 


MIDI CC #

   Config     12
   LFORange   13
   LFOSpeed   14
   LFOLoLmt   15
   LFOHiLmt   16
   Stages     17
   Feedback   18
   Mix        19
   Polarity   20
   OutLvl     21
